The clicking sound is the compressor shutting itself down on the overload.
Ge refrigerator compressor relay clicking.
Herbert midgley the internet legend shows you how to fix your clicking or ticking refrigerator.
The start relay usually looks like a small box plugged into the side of the compressor and its job is to turn the compressor on and begin the compression of the refrigerant gas that cools your refrigerator.
Start relay the clicking could be the start relay if the start relay is bad the compressor will not start and you will hear a clicking noise in 2 5 minute intervals.
Find the start relay on the compressor and remove it from its socket.
But the compressor which constricts refrigerant to cool it is doing nothing even though that clicking sound is supposed to be the start relay turning the compressor on and off depending on the thermostat reading.
Disconnect the power to the refrigerator and open up the compartment.
To check your start relay unplug the refrigerator.
To find out if this is bad first unplug the refrigerator.
The start relay is located inside the same compartment with the compressor and is plugged into the back of the main device.
Give it a gentle.
The clicking noise is the overload cutting the compressor off when it overheats from trying to start with a bad start relay.
The condenser coil is located near the compressor either on the rear or bottom of the refrigerator.
One of the symptoms that the relay is damaged is when the refrigerator heats up and certain clicks can be heard.
Save money and fix your own refrigerator.
If the condensor coils are dirty this can cause the compressor to run longer and.
Learn to test the start relay of the compressor.
Runner ic 4 refrigerator freezer compressor ptc start relay for frigidaire gibson ge whirlpool ropper kenmore replace 32330 wp2262185 wr07x26748 4387913 216594300 2 pack 4 8 out of 5 stars 28 12 99 12.
The fans are running so it sounds like your refrigerator is okay.
If the compressor is too hot or pulling a lot of amps the relay will break the circuit to the compressor to protect it.
This is the tubing through which the refrigerant flows after compression to dissipate the heat and prepare for expansion and cooling.
Since the temperature is too warm the clicking is probably your compressor overload relay.
